[brossow]

Originally Posted by 6D8_C10

Leviticus, is that with 1 1/2 rotor with 2 7/8 diameter?
What version is that? -2AA
What wheel is it for the 18s or the 20s?
If it is 20, will it be same mod for 18s?

Those are the revised 20s (-3-AA part #) as shown in his thread here. His hub seems to have been significantly thicker than those on my stock 1.25" rotors. (The measurements from my digital caliper are posted elsewhere in this thread.) No idea why his would have been different, but there ya have it. Measure before ordering because YMMV.

Originally Posted by smith2481

that is what I am asking if that is all I have to do with the 18s I dont mind that a bit I am all for getting them if not too much work

As I said in response to your PM, the 18s will require significant machine work on the hubs to make them fit as documented in the other thread. Leviticus just hit his with a grinder to knock down a bit on the edge. For some reason his hubs were apparently a lot thicker than mine, specs for which are posted elsewhere in this thread.