The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - C H E V R O L E T hood letter template needed

**Getter-Done** · 12-02-2018, 11:49 PM

Actually it is steel sheet metal.
I had first planned aluminum and a lot more detail .
Yes the right side is the set up.
This locates the Most important/ R that is in the middle.
The Twist drills required are #24 (0.152) & #29 (0.136)
The right has scribe mark for alignment.
The left needed trimming for the (relief) to match.
That is just the Ruff phase.
I got 1 more Trick I hope to get this tweeked this week.

Number 24 drill for big holes on left
and number 29 for locating holes on the right.

12-02-2018, 11:49 PM	#9
Getter-Done Senior Member Join Date: Dec 2009 Location: TN. Posts: 7,782	Re: C H E V R O L E T hood letter template needed Actually it is steel sheet metal. I had first planned aluminum and a lot more detail . Yes the right side is the set up. This locates the Most important/ R that is in the middle. The Twist drills required are #24 (0.152) & #29 (0.136) The right has scribe mark for alignment. The left needed trimming for the (relief) to match. That is just the Ruff phase. I got 1 more Trick I hope to get this tweeked this week. Number 24 drill for big holes on left and number 29 for locating holes on the right. __________________ ________________________________________________________________________________________ ____________________________________________ 84 Chevy K-20 63 Impala (my high school car) http://67-72chevytrucks.com/vboard/s...Crew Cab Build Last edited by Getter-Done; 12-02-2018 at 11:55 PM.