Ok guys I need some advice... I'm ready to order some parts to connect my steering column to the rack. My question is where should I reduce down to 3/4 to hook into the splines on the rack.
Should I get a 1" DD x 3/4" DD reducer and hook that directly to the column, and then run 3/4" shaft down to the center joint with a heim ( for support), and then to the rack?
Or should I go from the column with a 1" DD x 1"DD down to the center joint with a 1" shaft, and reduce there after the heim joint?
Or should I go all the way with 1" shaft, still using a center joint with heim, and reduce down at the rack?
I guess I trying to figure out if one is stronger than the other. I would think you would want to go as far as you can with a piece of 1" shaft since that"s the size coming out of the column. Or am I just over thinking this project?