The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

pitterpat · 03-26-2019, 12:03 AM

The hole, I'm going to patch it with sheet metal and pop rivets. I think the metal of the inner fender is too thin to weld and too much trouble. I'll use seam sealer on the patch, the patch will be on the inside. After I seam seal it I'll use the spray on undercoating.

I washed it off real good today, tomorrow I'll get all the stuff.

No, this isn't washed off, I'll pic tomorrow and post.

03-26-2019, 12:03 AM	#2
pitterpat Registered User Join Date: Jun 2015 Location: Indianapolis, IN Posts: 121	Re: New inner fender to me The hole, I'm going to patch it with sheet metal and pop rivets. I think the metal of the inner fender is too thin to weld and too much trouble. I'll use seam sealer on the patch, the patch will be on the inside. After I seam seal it I'll use the spray on undercoating. I washed it off real good today, tomorrow I'll get all the stuff. No, this isn't washed off, I'll pic tomorrow and post. Attached Images __________________ 1984 Chevy Custom 20 $2500 work done on engine and transmission 2010/ less than 1000 miles on it since. Here's my mild build thread, http://67-72chevytrucks.com/vboard/s...d.php?t=783971 Last edited by pitterpat; 03-26-2019 at 12:57 AM.