Well, I got the undercoating sprayed, mostly. I got the patches in the cab corners, not the outer, but the inner part that is against the end of the rear support. I also closed up a small rust hole at the bottom of the B pillar on the driver side. You could see it looking through where the corner was cut out. I found a couple small holes in the passenger side corner that will need a little work. That was all for today. The fumes from the heater were giving me a headache. It's not as bad as the diesel/kerosene heaters, but after 3 days, it bothered me.
I'm going to make the kick panel patches next, then cut down the corner patches. Motivation is strong now, I need to keep going.
