Quote:
Originally Posted by rodstored-72
luke,
THANK YOU!! exactly what I was wanting to see. My install looks very close to yours , but not near as clean . I know what you mean about a pair of hands. my nieghbor came over to lend a hand to hold the lines while I installed the hoses (wife tried)-but I was too strong for her.. . Curious: did you use the plate on the firewall due to factory wall "thinness"? The pics also confirmed my heater line connections, I was not sure which lines connected to the LS motor? . lastly what "vent" are you using for the gas tank(s)? If willing to share? I might try to copy the idea as well??
Thanks!!
|
since this truck was a factory air truck there is a big hole behind the plate, so id rather use the supplied plate than weld the firewall up.
the fuel tank vent is sold by Holley part #19-174 I made a bracket and used one on each fuel tank.