So the original GM throttle cable had the wrong type end on it. I found a couple of options to get different ends, but decided to hold off on ordering anything. I pulled the dodge throttle cable out of the old cab and put it in the gmc, and it fits like it was stock! While I was robbing parts, I went ahead pulled the proportioning valve off the dodge as well. I figure since I'm using to dodge brakes (on the axles) this would be set up for them. The bracket that supports the proportioning valve even bolted up to the GMC master cylinder like it was stock. I did cut off the part of the bracket that held the dodge ABS module. Then I hooked up the lines from the MC to the propp. valve. I still need to make some brake lines to finish that job up.
After that I started putting in the interior. Got the carpet and seats in.
