Please be Seated
Found a few hours yesterday to work on the K5.
Got the rear seat installation finished. For anyone reading it's 1/2" coarse thread X4 for the back bolts and the 2 front bolts are 7/16" coarse.
Longer bolts (1.5") came in for the front seats so I got those installed and even had enough time to get the sill plates installed as well. Not as much progress as I'd of liked but it's a pain in the butt to get the bolts lined up, through the carpet, mass loaded vinyl, and heat foam. But I slowly prevailed.
Also tossed in the floor mats. Look pretty good if I don't say so myself!
Updated punch list below!
PUNCH LIST
Under Dash
-Attached hidden antenna under dash
-Check carb gets to WOT with pedal travel
-Install glove box
Interior
-Install front seat belts
-Install t-case shifter, boot, + trim ring
-Install center console
-Install dimmer switch grommet
-Install steering wheel
-Install Rollbar mounted fire extinguisher
-Install door panels + door panel trim
Underhood
-Install radiator overflow reservoir
Final Wiring Touches
-Apply silicone and dielectric grease to wire connections/fuse block
-Install wire clamps along frame rail
Misc
-Get exhaust
-Double check all fluids
-Install rear bumper
-Diff breather hose for 14 bolt
-Double check door locks match ignition cyl key