The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Rokcrln · 06-21-2006, 11:01 PM

porterbuilt~ Thanks for checking for me. I am not in a big hurry just yet but as I drive to and from work I am always thinking about ideas. With my 70 2wd blazer I want to keep the rear notch as small as I can but still drop it to the ground. I am thinking I might be able to go with a smaller notch if I go with a C4 set up of sorts since the third member would be stationary and just the arms need to travel. I need to crawl under one and check it out some more. If I go this way then it would be a C4 up front as well but I am still thinking about the dropmember for my 71 swb. Only problem is I would need to chop apart my custom Sanderson hot coated headers to fit the steering shaft but I am thinking it would still be worth it.

Kevin
LFD Inc.

06-21-2006, 11:01 PM	#50
Rokcrln Senior Member Join Date: Jul 2005 Location: Winters Ca. 95694 Posts: 4,843	Re: Dropmember in a 69 C10 porterbuilt~ Thanks for checking for me. I am not in a big hurry just yet but as I drive to and from work I am always thinking about ideas. With my 70 2wd blazer I want to keep the rear notch as small as I can but still drop it to the ground. I am thinking I might be able to go with a smaller notch if I go with a C4 set up of sorts since the third member would be stationary and just the arms need to travel. I need to crawl under one and check it out some more. If I go this way then it would be a C4 up front as well but I am still thinking about the dropmember for my 71 swb. Only problem is I would need to chop apart my custom Sanderson hot coated headers to fit the steering shaft but I am thinking it would still be worth it. Kevin LFD Inc.