The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - HOW TO: Poor man's no-weld gas cap delete

shifty · 07-07-2007, 07:44 PM

Here is the end result: A semi-stock looking cover for your gas-hole (har har).

It doesn't look that bad up close or at a distance. It's a cheap solution for me to get by until I can weld everything up properly.

Total project time was 1.5 hours, with beer, and I made everything up as I went. Without beer, after reading this tutorial, you could probably finish the job in less than 45 minutes. I personally prefer using the beer method if you are of age, but remember - all things in moderation!!

Enjoy

07-07-2007, 07:44 PM	#8
shifty Questionable Join Date: Mar 2005 Location: Atlanta Posts: 13,376	Re: HOWTO: Poor man's no-weld gas cap delete Here is the end result: A semi-stock looking cover for your gas-hole (har har). It doesn't look that bad up close or at a distance. It's a cheap solution for me to get by until I can weld everything up properly. Total project time was 1.5 hours, with beer, and I made everything up as I went. Without beer, after reading this tutorial, you could probably finish the job in less than 45 minutes. I personally prefer using the beer method if you are of age, but remember - all things in moderation!! Enjoy Attached Images __________________ If I've got anything up for grabs, it'll be here: 7-hole gauge cluster for a 67-72 p/u FREE (link) I can't check the forum daily. If I don't reply to you within 24 hours, drop me a PM! I'm (hopefully) still alive and will reply faster to a PM.