made a little progress yesterday. Got some wiring stuff delivered. I soldered together some nice weather pack connectors for the fan setup.
Got the core support grounded to the frame.
Most importantly, I got all the temporary wires hooked up and some fuel in the tank for the test start. I did run the fuel pump to pressurize the lines and only had one leak at a loose line fitting. Tightened her up and back in business. I also cycled the pump till I heard the return line dumping fuel back into the tank. Very happy it works.
Dropped a bolt in the frame to hold the DBW pedal
I am a little concerned about priming the engine. It has been sitting for months and part of that time upside down. Any suggestions? This isn't like the old small block. I was thinking I would take out the plugs give a squirt or two of WD40 in the cylinders and dry crank till I have pressure. Then close it all up and give it a go? Hopefully next post will be a video of the motor living. On your mark, get set...
