The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - POR-15 failure

GMC87 · 10-07-2010, 10:37 AM

Thats odd, I have used POR on various project over the last 15 years. I have never followed the directions or done a proper prep, usually just wire brush off loose rust and paint chips then slap on a good thick sloppy coat. I have never had it chip or peel. I have used it on floor boards, under side of cabs or car bodies frame rails and such mostly just rusted areas or areas that I wanted to prevent rust. The only thing that I do follow is I store it in the fridge if I am going to store a opened can for any length of time.

10-07-2010, 10:37 AM	#13
GMC87 Registered User Join Date: Aug 2010 Location: N.Canton, Ohio Posts: 70	Re: POR-15 failure Thats odd, I have used POR on various project over the last 15 years. I have never followed the directions or done a proper prep, usually just wire brush off loose rust and paint chips then slap on a good thick sloppy coat. I have never had it chip or peel. I have used it on floor boards, under side of cabs or car bodies frame rails and such mostly just rusted areas or areas that I wanted to prevent rust. The only thing that I do follow is I store it in the fridge if I am going to store a opened can for any length of time.