I am going to replace all the visible fasteners with stainless button head bolts.
I polished them tonight.
Here is the process:
Chuck the bolt in a drill
Then run the drill and sand the head with 800 grit sandpaper.
Next, using green polishing compound on a loose cotton wheel, run the drill and press the bolt head to the wheel to polish.
Finally, run the bolt in the drill agains a cotton towel.
The whole process takes about 15-20 seconds a bolt.
Here are comparison picks:
The results are worth the effort for sure.
I did 108 in different sizes in about 45 minutes.
Steven