I test fit the driver's seat today at lunch. Whoever said these were "bolt-in" may have been exaggerating a little...
I can't see how I could use any of factory holes without fabricating some adapter tabs/brackets.
Because every adjustment on these seats is power I can't even check seating position until I get them wired up. I'll put power to them tonight and try and move them into a position that will make the mounting easier.
I'm not sure how I'll mount the passenger seat. It doesn't look like it has any way to tilt forward so I may adapt it to work with some of the original forward tilt hardware. After I get the driver's mounted hopefully I'll have a clearer picture.
Matt