The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**aotte1** · 10-17-2015, 08:58 PM

Last weld today, rear corner of the bed side panel at the bottom. Really tight area, with several different areas needing welded. Not pretty but fixed. Next time will use the stubby end for torch and short red head tungston tip. I did more floating of the puddle, versus dragging, as I had no room to move the torch. Pretty much held it by the cable as no room for my hand. As it shows did small areas, let cool then, did another small area.

10-17-2015, 08:58 PM	#100
aotte1 Senior Member Join Date: Oct 2013 Location: lousiville Ky Posts: 2,637	Re: 64' K10 Project Long Bed Last weld today, rear corner of the bed side panel at the bottom. Really tight area, with several different areas needing welded. Not pretty but fixed. Next time will use the stubby end for torch and short red head tungston tip. I did more floating of the puddle, versus dragging, as I had no room to move the torch. Pretty much held it by the cable as no room for my hand. As it shows did small areas, let cool then, did another small area. Attached Images Last edited by aotte1; 10-17-2015 at 09:09 PM.