[mopar346]

I didn't experience any frame difference with mine, other than the length. I had to cut about 3.5 inches off the back of the frame to allow the wheel wells to sit over the tires properly but I simply marked and drilled my holes in the frame. There were no brackets required the frame was squarely under the holes pretty much dead center. The rear tires would NOT sit in the stock wheel housings with mine, it might be different with a 4WD with a higher rear stance but on my 2WD suspension I had to move them in 3 inches as shown in my thread, yes a body lift would have done it but I am not a fan of those much less a 4 or 5 inch to clear the tires.