The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Pontitruck · 01-15-2019, 08:48 PM

Hello guys, I need your help.
I bought a 65 SWB project that was taken off the frame and assembled. It has a 5.3 with an AR5 manual set up but I am removing all of that including the PSI Harness to go to a 4l60e. It also came with an American Autowire upgrade kit and I purchased the Vintage Air kit for it.
Since my truck is assembled and the drivetrain is in place, can anyone recommend a project plan to wire it, install the vintage air and switch out the trans?
I'm feeling a bit overwhelmed but have a fairly decent mechanical skill set. If this were a classic Pontiac, I'd be much more comfortable.

Any ideas where to start is appreciated.
Thanks
Joe

01-15-2019, 08:48 PM	#1
Pontitruck Registered User Join Date: Sep 2018 Location: South of the Indy 500 Posts: 116	Project Checklist Help Needed Hello guys, I need your help. I bought a 65 SWB project that was taken off the frame and assembled. It has a 5.3 with an AR5 manual set up but I am removing all of that including the PSI Harness to go to a 4l60e. It also came with an American Autowire upgrade kit and I purchased the Vintage Air kit for it. Since my truck is assembled and the drivetrain is in place, can anyone recommend a project plan to wire it, install the vintage air and switch out the trans? I'm feeling a bit overwhelmed but have a fairly decent mechanical skill set. If this were a classic Pontiac, I'd be much more comfortable. Any ideas where to start is appreciated. Thanks Joe