|
Re: 86 GMC, Porterbuilt Mild front and rear
Quote:
Originally Posted by bigguy
I believe you need a 1” dd to 3/4” dd u joint. I bought all of my gear through Porterbuilt. I did end up getting some extra u joints because of the geometry of the shafts.
|
Yeah, I wish I would have. At the time I bought it I was a bit new to the C10 / PB game. 2013/14. I've had the front stuff a long time. Since then I've bought all of my rear parts and Accuair kit through PB. After getting all my parts I started my install. I have the motor out, and all of the front parts installed. Now I'm trying to get my steering shaft stuff going. Also, waiting on the Bonspeed wheels I ordered from Bonspeed 9 months ago. Not happy about that at all.
__________________
 '84 Suburban C10 Silverado - laying pinchweld to the ground on 22/24.
/Porterbuilt / Accuair / Bonspeed / Landsail / Auburn Gear / Richmond Gear / Moser / Raybestos / ProMaxx / Edlebrock / Street Demon / Taylor Wire / K&N / MSD / KillMat /
SOLD: 1985 GMC Sierra Classic 2500 3+3 Crew Cab Long Bed
|