The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - GRIZZ’s ‘79 - 2WD BLAZER Challenge over in London, England. “~It’s not a Project~”

Grizz1963 · 09-27-2020, 02:48 AM

Made up a small chassis number plate to add to the fibreglass body this week.

I will screw it inside the glovebox in the end.

The chassis number is on the chassis leg as expected, but not very well accessible.

I wondered if it will be visible once the motor is back in, and it has been painted in under seal.

Nice to have the right tools.

Thanks Bootfair.

Need to get the RX8 seats out of the C10 cab in the garage to start removing all the motors to lighten the drivers side up.

Also need to find out if MX5 rails can be used on them.

09-27-2020, 02:48 AM	#813
Grizz1963 Registered User Join Date: Dec 2012 Location: Rochester, KENT Posts: 10,480	Re: GRIZZ’s ‘79 - 2WD BLAZER Challenge over in London, England. “~It’s not a Project Made up a small chassis number plate to add to the fibreglass body this week. I will screw it inside the glovebox in the end. The chassis number is on the chassis leg as expected, but not very well accessible. I wondered if it will be visible once the motor is back in, and it has been painted in under seal. Nice to have the right tools. Thanks Bootfair. Need to get the RX8 seats out of the C10 cab in the garage to start removing all the motors to lighten the drivers side up. Also need to find out if MX5 rails can be used on them. __________________ MY BUILD LINK: http://67-72chevytrucks.com/vboard/s...585901]Redneck Express - 1966 C10 Short Fleetside MY USA ROADTRIPS http://forum.retro-rides.org/thread/...2018-humdinger IF YOU CAN'T FIX IT WITH A HAMMER, YOU'VE GOT AN ELECTRICAL PROBLEM MATE.