View Single Post
Old 09-27-2020, 02:55 PM   #814
Grizz1963
Registered User
 
Grizz1963's Avatar
 
Join Date: Dec 2012
Location: Rochester, KENT
Posts: 10,480
Re: GRIZZ’s ‘79 - 2WD BLAZER Challenge over in London, England. “~It’s not a Project

A good weekend, not a lot of car time, but all good.

No Bootfair, cold, miserable and windy.

So at about 2.00pm Sally was back and started a fire



So I took out the seats from the C10 cab and brought them up to the Rezin Rockit.



The plan was to remove all the motors from the drivers seat in order to lighten it.

At almost 27kg or 4.5 stone, it weighs a lot more than the passenger seat.

In the end I decided not to strip it, but rather to ask more questions.







And then with safety harness added.

But it is not going to work, unless I figure out a decent anchoring option that allows it to hold you in safely.



And a moment to grin.

How to take a selfie alone, in order to see what this will look like, plan the roll bar and also start thinking about what it would look like possibly cutting the screen down by 100mm or so.


Balance the camera in a tea mug on top of stuff, set 10 second timer ad race and jump into car up on axle stands.



And there you go.

Seat cannot go much lower.




.
__________________
MY BUILD LINK: http://67-72chevytrucks.com/vboard/s...585901]Redneck Express - 1966 C10 Short Fleetside
MY USA ROADTRIPS http://forum.retro-rides.org/thread/...2018-humdinger
IF YOU CAN'T FIX IT WITH A HAMMER, YOU'VE GOT AN ELECTRICAL PROBLEM MATE.
Grizz1963 is offline   Reply With Quote