OOOOOP'S I do not know what happened but I did it on both sides. No bit deal I will just cut a filler strip and tack it in
Now everything you will do for the front of the bed will be just like the rear. Once it is all tacked you can start welding it up by adding tacks between each existing tack. Do not try and weld one section in one shot or you will have a very good chance of warpage. I only tacked each area so I would be able to tack one panel and move to another while the first one cools and by the time I work my way around all four side I am ready to start all over.
I do not have any finished shots of the bed side because I ran out of .023 welding wire before I could finish. So in the next few days as time allows I will get back to this and finish it up. I still need to fine the gas tank that I will mount under the bed and install the gas door so I can finish body work. Once the body work is done I will pull it off for paint and then cut the 12" out of the frame and do the flip kit.
Kevin
LFD Inc.