|
Re: Battery Cables and Battery Relocation?
Quote:
Originally Posted by wixthedog
Did you run 1/O cable or 1AWG? I ran some V=IR numbers the easy way and found that there is not much of a difference at start up. The price difference is negligible really.
What I may do is run the 1/O to the solenoid and then the output solenoid to starter stud in 1AWG.
|
I purchased it from NAPA so it was 1AWG because it was the biggest they had for making a custom cable. The length on my set-up is not much longer than stock though so that's different (slightly, but different). I also matched the primary ground size @ 1AWG.
All subsequent grounds (6x) were 4ga (motor to frame rails/both sides; core support to frame rails/both sides; cab to frame rails/both sides). Alt to BATT is also 4ga if I remember correctly.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|