My plan is to run air ride and set it down pretty low. Not sure how low but I felt that the trailing arm may drag at times. I flipped over the frame and started to shave.
Welded in a piece of flat plate.
Then cut some holes out for the exhaust.
Welded in some 4 inch pipe to regain some strength.
Well that's about all Ive done so far. I only work on it on the weekends and my wife is incredibly understanding with the time and cash it takes to do a project of this size. I hope everyone enjoys these pictures and keeps following along with my progress. Ill try and update it weekly. Comments and suggestions are always welcomed.