Quote:
Originally Posted by DBD
about a 3/16 bead on the ends is all that's needed, along with a 1/4 or so "goober" at the ends to seal to the intake gasket. more just ends up in the cam valley. taking a wet finger and putting a nice tuckpoint on the outside after you torque the manifold shows you know what you're doing
|
Dead on but it also depends on the intake. My last eddy performer RPM takes a little more for the end gap on the block. It has also been prone to getting a leak at the sealer also. Only manifold that I have owned that had an issue and neither it or the heads have been milled.