[sparkydog]

Took out the GMC cross member that was preventing my IH bed from sitting lower down on the frame. That dern cross member was only in with 6 rivets but it put up a fierce fight. However eventually they gave up. Now the front of the bed is where it will stay and I can move on to the cab/floorpan and finalize their positions and start tack welding. Looks like my computer sketches were just about right on. From the photos I would say the cab is going to drop another .6" or so.

Wish I could get the whole rig outside of the garage and take a nice side shot of everything. But for now I'll have to stick to the close-in 3/4 side shots.