Quote:
Originally Posted by dennislbrooks
My new glass is 2 ply - safety.
Was the original door glass in a 59 single ply? I am not sure if that lip seal can be forced in the frame with 2 ply glass.
Now for order of events putting all glass in door --- this is a question.
????????????
1, Bottom door stop
2. Outside channel
3. Place completed window frame and glass inside door
4. Place completed vent window assembly in
5. Align window in all channels
6. Fasten vent window assembly
7. Place regulator and fasten
8. Inside and outside felts.
I am complete on the left door (all is well) but a monkey might have looked like he knew more about doing it.
|
You can leave the bottom window stop (the square rubber block) out until the install is good and everything is in place. Check and make sure your inside and out felts go into the holes easy once glass is in ,they are a bear to install. Remember both windows go in at the same time. And if you have new paint ,Tape the top of door where you are putting window . One slip there goes the paint. Other than that your good to go.
:
Also I have the 2 ply glass, it is the same thickness . A helper makes the job flow smoother for sure