[oldman3]

Pic 1 I start out doing about 4 pleats at a time. Spray the panel, then the material, use a brush to get in the pleat. Let everything set for about 5 minutes to tach up. Start smoothing the material on the flat surface, then feed material into low spots. I'm sorry I got ahead of myself and forgot pics of how to do this, but I show it on the drivers panel later.

Pic 2 Here is the first 4 pleats, that have been pressed into the low spot with bondo spreader or screen door roller. Continue doing about 4 or 5 pleats till finished.

Pic 3 Then glue to back side and staple down.

Pic 4 Remove extra material.