The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Andy4639 · 01-30-2020, 10:36 AM

Thanks guy's. I haven't found a floor mat yet for it, not sure if I want one though. I've been thinking about buying some diamond plate pattern rubber matting and doing it with.
I want to add the intake & 4 barrel first though. Going with the one on the right. Somebody knocked the center bolt hole flanges out of it to install on a later model motor. I've been told they will be fine just add some washers. It was free so it's worth a try.

01-30-2020, 10:36 AM	#38
Andy4639 Old member Join Date: Jan 2002 Location: Liberty, & Garden City S.C. , U.S. Posts: 19,936	Re: The Pusher! Thanks guy's. I haven't found a floor mat yet for it, not sure if I want one though. I've been thinking about buying some diamond plate pattern rubber matting and doing it with. I want to add the intake & 4 barrel first though. Going with the one on the right. Somebody knocked the center bolt hole flanges out of it to install on a later model motor. I've been told they will be fine just add some washers. It was free so it's worth a try. Attached Images __________________ 1971 LWB Custom, 6.0LS & 4L80E, Speedhut.com GPS speedometer & gauges with A/C. 20" Boss 338's Grey wheels 4 wheel disc brakes. My Driver Seeing the USA in a 71 Upstate SC GM Truck Club 2013,14 and 2016 Hot Rod Pour Tour http://upstategmtrucks.com/ Get out and drive the truck this summer and have some fun! It sucks not being able to hear! LWB trucks rule, if you don't think so measure your SWB! After talking to tech support at Air Lift I have found out that the kit I need is 60811. Per the measurements I gave them. Ride height of truck inside spring and inside diameter of springs.