View Single Post
Old 08-04-2014, 04:53 PM   #82
jbclassix
Junk Yartist
 
jbclassix's Avatar
 
Join Date: Jul 2009
Location: Greeley, CO
Posts: 2,203
Re: NP 205 Rebuild and Info

Quote:
Originally Posted by woodsrat View Post
Just looked at the NP205 thread, What a great job on that!

I have a 1984 GMC 1 ton 4x4 transfer case stuck in low range or neutral.
Can move the low and neutral pin with a pry bar to chance them but Can't get the lever to go to 2 wheel or 4 high.

Now I am wondering if maybe the detent balls are out of place or if it has a broken spring in the one shaft that won't move, Any chance that can happen?

My linkage is defiantly different than that one in the pic. That looks like a nicer set-up.
I dont know what year GM started using the 4WD switch, but if yours has that, then I would check to make sure that isn't the culprit.

On the 205 you can also remove the PTO cover and gain easy access to your HI-LOW shift fork.

Both rods have to move to the NEUTRAL possition for the t-case to be in NEUTRAL. Does the LOWER one move at all, or only the upper?
__________________
-Jeremy

YOU ONLY FAIL IF YOU STOP TRYING

70 Crew Cab Build Link

70 GMC Suburban 4X4 build thread

95 Yukon Daily Driver

Rebuilding an NP205

Last edited by jbclassix; 08-04-2014 at 05:20 PM.
jbclassix is offline   Reply With Quote