Re: Wampus Cat
I started a mock-up for the fuel filler in the rear corner of the bed.
I found an old piece of tread plate in a junk pile, so it has some nice patina to match the existing bed. This tread plate is tough to bend, so I used a side grinder and cut off wheel to cut the plate to size, cut a relief line of the back side of the bend, and then used the torch to heat the area while bending it using a vise and a hammer.
The pictures show the first pass at the mock-up, but I think I will shorten it a quarter inch or so to match the top plate height with the body line on the inner bed wall. The fuel filler it self is a 316 SST marine piece; White Water Stainless Deck Fill, Gas w/Vent 1-1/2" Hose #6005S-SCV.
When I sent a picture of the mock-up to my brother, he commented: "Should easily sustain the sliding cargo test." :-)
.
|