View Single Post
Old 12-22-2007, 02:24 PM   #10
Rokcrln
Senior Member
 
Rokcrln's Avatar
 
Join Date: Jul 2005
Location: Winters Ca. 95694
Posts: 4,843
Re: Rocker replacement 101

If the kick panel fits good and it should if you have been following the steps Go ahead and weld, grind and prime.
Next is the A-post, you will want to trim some off the top or alot depending what kid of shape your is in. Mine I needed about all it had so I trimmed of about 1/4" and bolted it back in place for it's last scribing. Then I pulled it off and re-cut the A-post to the new scribe line. Then for the last time bolt it in a weld it up. Make sure you have cut out the hinge bolt holes if your patch is that high. Once you grind it smooth, prime it and move on to the outer rocker!

For the rest of this you will need to go to page two post 33 because I did not leave enough blank posts and took to many pics!

Kevin
LFD inc.
Attached Images
     

Last edited by Rokcrln; 12-23-2007 at 07:12 PM.
Rokcrln is offline