Re: 86 k 20 project "cletus"
Quote:
Originally Posted by joe231
the way I did my corners was to hit the area where the spot welds are with a wire wheel, then you can see to use a spot weld cutter to cut the spot welds out.
here is the one I used from Harbor Freight.
http://www.harborfreight.com/3-8-eig...ter-95343.html
it may be cheap but it is effective, it also helps to drill a small pilot hole in the center of the spot weld to keep the cutter in the right place
|
Great idea! Were you able to locate all the spot welds that way and leave the inner cab corner in tact?
__________________
Project #1 "Pops"--1980 Chevrolet Scottsdale C10 3rd Generation in the same original owner family. GOAL: Restore to "almost" original.
View Project Pops HERE
Project #2 "Cletus"--1986 Chevy K20 4.10 Gear Ratio GOAL: Restore into a heavy duty work/plow rig
View Project Cletus HERE - SOLD
DD--2008 Duramax CCSB
|