[msaintg]

Worked on the seat belt mounts. I also cut and welded the gas fill tube in a different position so that it lined up better with the fender. Ya the pic shows the fuel line passing through the frame... only place to put it. I could not run the filler tube above the cross support because it would get squashed by the bed and I could not run it below the frame because it would be too low going into the gas tank. It is actually going to be a little low already. I will box that in later.... all's good. Mounting the upper shoulder nut was pretty easy but mounting the lower part required me to have to build a box and weld it in to properly recess the unit. I screwed up and welded the box together with the seat belt assembly installed.... the heat from welding melted it. Now I have to buy new seat belts. damn.