[hotsam]

This allowed the passenger side to fit nice and snug in the frame pocket on the top and bottom frame runners and bolt to the crossmember and be bolted in. The tab that lays against the inside vertical part of the frame on the rear of the side mount was able to be drilled and bolted at this time. I also slotted this hole to the top a little to stay away from the bottom of the frame where it turns in at the bottom runner. It just kept the hole higher and out of the bend. The driver side mount sits on top of the crossmember where the two bolt together.. So I had to shave that thickness (crossmember) from the front of the mount and I notched the holes to the top just a little.. It shaved to the bottom of the mounting holes.