[KMC3420]

Originally Posted by 67C10Step

72C20 - Yeah, but as my wife says: At least I don't have to go from bar to bar looking for you. I know right where you are when you disappear.

KMC3420 - I would like to know more about the patch panels. I need to do this exact same repair only my truck and was looking at it over the weekend trying to come up with a plan.

I started out by cutting out the old to use as a template and then measured the template. From there I put my measurements on a flat piece of sheet metal. I use a bender I made for my shop press to bend up to 90 degrees. For cutting I use my right and left hand tin snips. Just take it nice and slow and sneak up on your final fitment.

Template


Template


Bender