The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 47-55.1 A few general questions about my project

**mongocanfly** · 06-22-2020, 10:45 PM

I used 3/4"dd and 1"dd on mine..
most references mean the 3/4dd is the solid shaft and the 1"dd is the hollow side that slips over the 3/4dd..giving you a slip section in the steering
works on the same principle and a factory steering shaft

I used dexcool in mine because that what the LS gets from GM.. no other reason

.

06-22-2020, 10:45 PM	#4
mongocanfly Post Whore Join Date: May 2015 Location: Alabama Posts: 14,585	Re: A few general questions about my project I used 3/4"dd and 1"dd on mine.. most references mean the 3/4dd is the solid shaft and the 1"dd is the hollow side that slips over the 3/4dd..giving you a slip section in the steering works on the same principle and a factory steering shaft I used dexcool in mine because that what the LS gets from GM.. no other reason . Attached Images __________________ Mongo...aka Greg RIP Dad RIP Jesse 1981 C30 LQ9 NV4500..http://67-72chevytrucks.com/vboard/s...d.php?t=753598 Mongos AD- LS3 TR6060...http://67-72chevytrucks.com/vboard/s...34#post8522334 Columbus..the 1957 IH 4x4...http://67-72chevytrucks.com/vboard/s...63#post8082563 2023 Chevy Z71..daily driver Last edited by mongocanfly; 06-22-2020 at 10:57 PM.