Now to the passenger side cab corner. Here I am going to have to replace the end of the rear brace, the cab corner as well as a small part of the floor.
Here is where we started after opening up the cab corner. As you can see the inner floor in that area needs replacing as well.
I guess the PO thought it would be easier to cut the corner off at an angle instead of replacing the corner correctly. As you can see there is an interesting mud job as well. I have seen worse, this mud was only about 3/8" thick.
Here is it ground down to to the area I will end up replacing anyway. No reason to clean all that off if I am going to replace it anyway. The black like is where I cut for the new panel to go on.
This is the floor section viewed from the rear of the cab. I removed the outer cab corner section. I will replace this entire section.
This is the same pic as the first one on this page, just with those previously mentioned areas removed.