Issue #1
So I also had a play today and struck problem #1 - the lower arms wont fit over the lower mounts.
Either both arms I have are too narrow or the lower mounting points on the subframe are too wide. I measured the following and if anyone can shed some light that would be good (anyone with first hand experience)
I measured
10- 1/2” (267mm) inside of bush to inside of bush on either lower arm.
10- 3/4” (273mm) the width outside to outside for mounts on the subframe.
While I plan on changing the bushes before final install they should be similar to what’s fitted.
As you can see by above dimension and photos below there seems to be a ¼” (6mm) discrepancy.
I expected the bushes to be tight but no matter what I try it just won’t go over, the one I did get over smashed the inside lip of the bush off (which im replacing later anyways).
Any ideas help appreciated.
|