[sdwolff98]

Well finally getting somewhere closer to the interior setup lol. Started working on the steering column tonight and start in on the initial fitting in the truck. I bought a Ididit "Direct Fit" as they said column through summit. When I got the column it shore as heck was not a direct fit as they said ijits!!!! there were no provisions for the factory bolt assemblies on the column like my original setup. Well after looking and experimenting with several chevy columns of later makes I decided to stick with this tho the column wiper and bright controls would have been very nice lol. Am gonna make the besst of this and have come up with a few monds to the column to make it work better then their design Ideas.. At the tops of the column inside will drill two small 5/16 or slightly larger holes since I have some small jnuts that will slip in to the column housing without hitting the steering shaft inside and put some small bolts through this area plus a t clamp setup to keep the column from rotating on me while driving will do a very similar setup inside the engine compartment as well will take more pics as it progresses. I am working on getting the column exactly where I want it before I start drilling and putting things in permanent. Tommorrow will be putting the seat in the truck and getting the steering wheel and column lined up so it is correct then in tilt mode and not sticking off at an angle like I first had it lol......

here are some initial pics!
yeah the blue doesnt match my trucks color but hell was all I had at the time *chuckles*

Sean