[BlueBullet]

The throttle cable I had on hand was a little too long so I had to give it a trim. This is the second time I have done this mod and it's pretty easy if anyone is not familiar with it. First step is to figure what you need for a length. Then cut cable stop off back side and pull apart. Then with a firm grip pull both ends off cable housing. This one didn't cooperate so I had to drill out using a 13/64 bit. Just barely put pressure on the drill and it will zip in and stop when it gets to the bottom of original cavity. I cut cable housing to desired length with a cut off wheel on an angle grinder. Once done push the ends back on and insert cable. I then installed and rest pedal and clamped on new cable stop.