The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - INSTALL: Tennman's Sidemarker Fuel Fill on a Stepside

jorgensensc · 11-17-2003, 01:05 AM

All that is really involved is cutting the fuel door to match the width and height of the sidemarker lense. Measure between the white ridges up and down (approx. 2 1/2"), but measure to just outside the bolt holes ( about 1/8" past on both ends turns out just past 3 1/2" length). My fuel door faceplate (big round part) seperated from my hinge piece, so I had it welded together again.
You can see the weld spot on the side in this pic.

11-17-2003, 01:05 AM	#10
jorgensensc Registered User Join Date: Jul 2003 Location: Cypress, Tx Posts: 4,006	All that is really involved is cutting the fuel door to match the width and height of the sidemarker lense. Measure between the white ridges up and down (approx. 2 1/2"), but measure to just outside the bolt holes ( about 1/8" past on both ends turns out just past 3 1/2" length). My fuel door faceplate (big round part) seperated from my hinge piece, so I had it welded together again. You can see the weld spot on the side in this pic. Attached Images __________________ 1972 C20 Suburban- Big Blue Betty '56 Chevy Bel Air Sedan- Frame up Restoration -What would you attempt to achieve if you knew you could not fail?- -I Refuse To Tiptoe Through Life, Only To Arrive Safely At Death's Door- R.I.P. EAST SIDE LOW LIFE