The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Tito19 · 03-02-2014, 02:41 PM

Removed it because she was leaking from what seemed to be the input shaft and a few of the end caps. The gears moved fine with no up and down play. When I opened her it looked like PO had done something to it, there was gasket maker on the access panel. I priced out every thing available on Rock Auto, which were all the seals and bearings and came to 90 some thing dollars. That's out of my budget so I'm going to do the seals and one pair of bearings, thinking ideler bearings.

03-02-2014, 02:41 PM	#9
Tito19 Registered User Join Date: Feb 2013 Location: Watsonville California Posts: 47	Re: Rockwell t221 rebuild?? Removed it because she was leaking from what seemed to be the input shaft and a few of the end caps. The gears moved fine with no up and down play. When I opened her it looked like PO had done something to it, there was gasket maker on the access panel. I priced out every thing available on Rock Auto, which were all the seals and bearings and came to 90 some thing dollars. That's out of my budget so I'm going to do the seals and one pair of bearings, thinking ideler bearings.