|
Re: Closed knuckle-ball clean up advice needed
maybe super clean / degrease / wire wheel / then j.b. weld the low spots and let cure and then sand down smooth the whole ball .
i know a guy who did this on a semi float axle were the seal grooved the surface . was still going strong after a year or two when i heard the story from him .
__________________
77-k30lb BIG truck build .
87-k30lb budget beater build .
85-k30lb the plow machine build .
85-c10sb summer fun toy .
-----------------------------
HOLLEY SNIPER efi = worst case of p.i.t.a i ever had .
EDELBROCK pro flo 4 = best deal going so far . love my setup works great.
|