Re: Closed knuckle-ball clean up advice needed
Quote:
Originally Posted by 61K10
somebody on here did the j-b weld on their knuckles. Sanded them down smooth, and worked fine. I put new knuckle bearings in my axle but just put the org shims back in. You might have a bad bearing?
|
Yes, going to R&R the bearings, but if I go to that expense and trouble I want to make sure the preload on the bearings is perfect (or as close as I can get it)
__________________
65 short stepside K10
292-SM420-T221
8 lug closed D44 front
NoSpin HO72 4.10 rear
|