Thanks!
i finally got around to drawing and cutting/forming/welding the under engine crossmember. this will be bolt in as well to facilitate removal of the drivetrain should that be necessary. it needs the welds finished and then i can get the frame mounting points blasted out. i think i will be able to remove all of my angle iron bracing after that!
i had to toss in a few flared holes for that race truck feel, and as a plus to the cool factor they actually make the material stiffer.
the spreader tubes are welded in at the bolt holes here
approximation of the placement. holding it with my hand and taking a picture was a bit challenging. it will be forward of the axle housing to avoid interference. hopefull it will help lend some rigidity to the steering box area as well.
Ryan