The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - '66 Sunbeam Minx Project - F20C/6sp/4-link/Discs...

Frizzle Fry · 04-26-2009, 11:29 AM

Then, since my degree finder was loaned out, I moved back to the front.

This is a template of the S2000 frame rail with wheel center and rack center positions marked. The rack center is pretty far back and requires the engine to set back further than I had initially expected:

This gave me a good excuse to get the engine set back as far as possible. I had a couple inches left at the firewall but the intake was the limiter:

Intake plenum cleaned up a bit (unused mounting bossed removed):

Spacial conflict resolved. You can see that the throttle pedal arm shape works out perfectly for this:

The engine went in and back out again and more material was freed:

04-26-2009, 11:29 AM	#105
Frizzle Fry Registered User Join Date: Aug 2005 Location: Hillsboro Oregon Posts: 6,449	Re: '66 Sunbeam Minx Project - F20C/6sp/4-link/Discs... Then, since my degree finder was loaned out, I moved back to the front. This is a template of the S2000 frame rail with wheel center and rack center positions marked. The rack center is pretty far back and requires the engine to set back further than I had initially expected: This gave me a good excuse to get the engine set back as far as possible. I had a couple inches left at the firewall but the intake was the limiter: Intake plenum cleaned up a bit (unused mounting bossed removed): Spacial conflict resolved. You can see that the throttle pedal arm shape works out perfectly for this: The engine went in and back out again and more material was freed: