Front Output Shaft Help?
Het guys i'm doing a reseal on my 205 outta my 78 k20 and the front output shaft slipped out the back. I got it back in following your guide but the front big bearing is a pain to get back in unless i hammer it in. Then it just falls back out almost. The case is 2HI but when i set it in i can spin just the front shaft no prob. But the other side from the tranny to rear axle it spins both. Is this normal in 2HI? I'm worried of puttin it back together and it bein wrong... Rant over lol Thanks too
Posted via Mobile Device
Posted via Mobile Device
Posted via Mobile Device
__________________
When in doubt, throttle it out!
1974 Chevrolet Custom K20
2005 Ford Ranger Edge
1985 Chevrolet Custom Deluxe C10
|