To get caught up hears a couple more pictures.
The first pic shows the axle with the BK1 seal kit laid out next to it, on the right is the bronze washer i pulled off my axle, in the middle is the plastic washer on the left is a V seal and inside is a seal that does fit inside the back of my spindles next to the needle bearing but there wasn't one of these seals in there when i took it apart, My spindles being the small spindles only had a bronze washer and a seal on the back side of the spindles. But the parts list called out the BK1 kit to be used as well, so when i saw the parts list breakdown i wondered if the rubber V seals rotted so bad they fell off? or did some hack get to this truck and not use some of a a kit many years ago? but after looking at it i don't see how the kit would possibly work in my application. I also received the seal for the large spindles as well, it had the wrong ID. both the kit and seal will be returned.
2nd pic shows the Bronze washer on the axle, the washer in the BK1 kit is plastic and has a larger diameter, if i was to use just that washer i'd have to grind the OD down to fit inside the axle sleeve.
Long story short, unless someone can chime in and tell me I'm missing something on the BK1 kit as far as using the V seal then I'm gonna proceed to reuse my bronze washers and i located the new seal for the back of the spindles..
http://www.rockauto.com/catalog/more...801&cc=1051445
3&4, knuckles have been installed.