Daughter is responding well to treatment…
After a couple of busy days at work, and some appts for today that had to re-schedule, DAY OFF!!!
Other than a trip to Lowes to grab some Top Soil, Manure & Sand (for a small garden area) I was able to get some truck time in...
FIrst a couple of pics of the Trans crossmember bolted in…
IMG_2835 by
ta2don, on Flickr
IMG_2836 by
ta2don, on Flickr
Yesterday I grabbed the crossbreed U-Joint and here's a shot of it on the rear-end pinion… The pinion section is just a bit narrower and the end caps a bit smaller in diameter then the Driveshaft section…
IMG_2915 by
ta2don, on Flickr
The Driveshaft installed...
IMG_2925 by
ta2don, on Flickr
Finally I started mocking up the Serpantine Belt set-up… The A/C Compressor is just there for belt placement, I will be using an A/C delete pulley until I save enough pennies for a vintage air system… The Alternator is AWOL...
Gotta pick it up Monday from the rebuilder… The bearings were toast...
IMG_2928 by
ta2don, on Flickr
Finally, a shot of JoJo sitting in the truck as we arrived at the studio this morning...
IMG_2924 by
ta2don, on Flickr