The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

6BT 56 · 02-10-2013, 10:52 PM

So a little more to report today. The eng is back in for another test fit.

The crossmember is where I wanted it to be and position of the eng is good too. I got my intake tube figured out today as well. I have to cut 2 inches out then Im good to go.

I think the eng will be in for a bit this time. I'd like to get the hyd clutch all good to go and check the exh for fit around the firewall. Will likely do some minor adjusting on electrical as well to make sure everything is good and the eng can stay in the hole next time. It's touch and go installing this much eng with a eng hoist !

A few pics .. Enjoy

02-10-2013, 10:52 PM	#116
6BT 56 Registered User Join Date: Dec 2012 Location: Coldwater On. Canada Posts: 551	Re: My 56 6bt 4X4 build. So a little more to report today. The eng is back in for another test fit. The crossmember is where I wanted it to be and position of the eng is good too. I got my intake tube figured out today as well. I have to cut 2 inches out then Im good to go. I think the eng will be in for a bit this time. I'd like to get the hyd clutch all good to go and check the exh for fit around the firewall. Will likely do some minor adjusting on electrical as well to make sure everything is good and the eng can stay in the hole next time. It's touch and go installing this much eng with a eng hoist ! A few pics .. Enjoy Attached Images __________________ 56 gmc 4X4 Cummins 5 spd 60F 70R 2005 Ram 3500 DRW cummins 4X4. 2006 Conolift 9/15. 2011 F 350 winter beater New 2018 ram 3500 drw 4x4. Makes my 2005 Look as if it's been running on 4 cyl since new ! My Build http://67-72chevytrucks.com/vboard/s...d.php?t=556908 Last edited by 6BT 56; 02-10-2013 at 10:55 PM. Reason: sp